Aironet AP2200-E Guide de l'utilisateur télécharger pdf (Page 13)

If using Thinnet cabling, attach the cable to each end of

a BNC T-connector, if applicable, then slide the

T-connector onto the unit’s 10Base2 BNC connector.

If the Access Point is at the end of the Ethernet cable, a 50-

ohm terminator must be installed on the open end of the T-

connector.

If using 10Base5 (Thicknet) cabling, attach the

Transceiver Connector to the unit’s 10Base5 AUI Port. Slide

the locking mechanism in place. The other end of the

Transceiver drop cabling should connect to an External

Transceiver.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Pas de commentaire

Aironet AP2200-E Guide de l'utilisateur Page 13