Aironet 2200 Guide de l'utilisateur Page 79

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 108
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 78
Utilities 3 - 31
Performing a LinkTest (Linktest)
Use the Linktest function to test the link quality between the Aironet
Client Card and other nodes on the Radio Network.
When you run a Linktest, the Client Card sends a sequence of packets to
a target destination node—either an Aironet Client Card (if running in
Non-ARLAN mode) or to an Aironet Access Point (if running in
ARLAN mode). If the radio quality is good, the target destination will
receive the packet then send the same packet back.
Before you run the Linktest, make sure the target destination node is
powered up with the antenna attached, is within radio range, and is set to
the same SID, bit rate and frequency, or channel.
The Aironet PCMCIA unit displays the number of packets sent, number
received, and percentage lost, which is a reflection of the link quality.
Keep in mind that packets will be lost, however, the upper layer drivers
and software combined with radio retries ensure a constant connection.
When you select the Linktest parameter, the Linktest menu appears. To
pause the Linktest at anytime, press the P key.
Perform Link Test
Destination Address Not Specified
Packet Length 512 bytes
Number of Packets 100 Packets
Time Between Tests 3 seconds
Packets/Stats Update 5 seconds
Perform Link Test
Continuous Link Test
Vue de la page 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 107 108

Commentaires sur ces manuels

Pas de commentaire