Aironet AP3500-E Guide de l'utilisateur télécharger pdf (Page 23)

Configuration

3- 1

Configuration

This section describes the methods used to access and

configure the Console system of the Aironet Access Point.

This system contains all commands necessary to initially

configure and monitor the operation of the unit.

Accessing the Console System

There are many ways in which you may configure and

monitor the Aironet Access Point. When the unit is first

powered up, basic configuration must initially be performed

by accessing the Console serial port.

To gain access through the serial port, the Aironet Access

Point must be connected to a terminal or a PC running a

terminal emulation program. Set the terminal to 9600 Baud,

No-Parity, 8 data bits, 1 stop bit, and ANSI compatible.

The Console system is organized as a set of menus. Each

selection in a menu list may either take you to a sub-menu

or display a command that will configure or display

information controlling the unit.

Once the Aironet Access Point has been assigned an IP

address, you may then access the Console remotely using:

•

Telnet protocol from a remote host or PC

•

HTML browser, such as Netscape Navigator from a

remote host

•

Simple Network Management Protocol (SNMP) from a

remote network management station

1 2 ... 18 19 20 21 22 23 24 25 26 27

Pas de commentaire

Aironet AP3500-E Guide de l'utilisateur Page 23