Aironet AP2200-E Guide de l'utilisateur

Aironet Wireless Communications, Inc. • 367 Ghent Road, Suite 300P.O. Box 5292 • Fairlawn, Ohio 44334-0292User’s Guide2200 and 1200 seriesWireless Acc

2Radio Node - A PC, notebook computer, etc. containing aWireless LAN ISA, MCA card or PCMCIA Adapter.End Node - A Radio Node that is at the end of the

3The Root Unit will have registration information for all nodeson the radio network in the tree.Optional long range antennas are shown below; a range

4Installing the HardwareWith the unit powered off, attach the RP-TNC antenna tothe antenna connector.Do not over-tighten when connecting, finger-tight

5If using Thinnet cabling, attach the cable to each end ofa BNC T-connector, if applicable, then slide theT-connector onto the unit’s 10Base2 BNC conn

6If using 10BaseT (Twisted Pair) cabling, plug the RJ-45connector into the 10BaseT (Twisted Pair) socket andconnect the other end of the cabling to a

7When power is initially applied to the Access Point, all threeIndicators will flash yellow, red and then green, in sequence,to test the functionality

8Configuring the Access PointTo configure the Access Point to communicate with endnodes or repeaters, you must first use the Console Port toset the fo

9From the Main Menu, type Configuration Ident Inaddr andthen type the applicable address.System Identifier (SID)The SID is a unique identifier that is

10Channel (1200 Series/900MHz Models)The channel must match that of other nodes on the RFnetwork. The default channel is the center frequency withthe

11Where to Go from HerePlease ask your Aironet representative for theAP1200-E/AP2200-E Technical Reference Manual.In the Technical Reference Manual, y

Aironet Wireless Communications, Inc.No part of this document may be reproduced or transmitted in any means,electronic or mechanical, for any purpose,

12

iManufacturers Federal Communication CommissionDeclaration of Conformity StatementModels : AP1200-E, AP2200-EManufacturer :Aironet Wireless Communicat

iiDepartment of Communications - CanadaCanadian Compliance StatementThis Class B Digital apparatus meets all the requirements of the CanadianInterfere

iiiDeclaration of ConformityAironet Model Number:AP2200-EApplication of Council Directive: 89/336/EECApplication of Council Directive: 72/23/EECCE Typ

ivSafety InformationThe FCC with its action in General Docket 93-62, 1997, hasadopted a safety standard for human exposure to radio frequency(RF) elec

vTable of ContentsBefore You Start ...1Terminology ...

vi

1The purpose of this User’s Guide is to allow you to installand configure your Access Point so that an end node oranother Access Point (acting as a Re