Aironet PCI4810B Guide de l'utilisateur télécharger pdf (Page 41)

Section 2: Using the WinDGS Utilities

ber of packets you specify on the Number of Packets set-

ting.)

Destination is Another Aironet Device

Click this check box if the Access Point you named in the

Destination MAC Address field is an Aironet Access Point.

Number of Packets

This parameter sets the quantity of packets that will be sent

during the test.

Packet Size

This parameter sets the size of the packets that will be sent

during the test. You should use a packet size that will be

typical during normal use of the system.

Data Retries

This parameter sets the number of times a transmission will

be retried if an ACK is not returned by the destination

device. Click None for no retries, or Default Retries for the

firmware’s default value for retries.

Data Rates

This parameter sets the bit rate at which packets will be

transmitted. No rate shifting will occur during the test.

Delay Between Packets

This parameter sets the delay (in milliseconds) between

successive transmissions.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 83 84

Pas de commentaire

Aironet PCI4810B Guide de l'utilisateur Page 41